For many years, the bespoke ChlorGuard control panel provides a robust philosophy for valve shutdown while also offering feedback signals so that the end user can monitor the status of the system. Process functionality has also been built in to assist the end user with activities such as closing the gas valves of an empty vessel before replacing.
|H760mm x W415mm x D315mm
|Zintec steel welded construction. Separate pneumatic & elactrical compartment. Hinged lockable outer cover c/w 3 mm perspex panel
|2 pack epoxy – RAL 1021
|110/230Vac - 50/60Hz
|Control ~ Pneumatic
|Manual, Automatic, Isolate via status control levers door mounted
|Control ~ Electrical
|Signal from gas detectors. Manual from remote closure button. Key test switch
|Alarm, mains power, stand by low battery, DC fuse, Pressure.
(Volt free contact)
|All NC or NO contacts available - Mains power failure, low pressure, low battery, alarm & levers not in open position.
|12Vdc for NC and 24Vdc for NO
|12V DC Power take off for strobe light to indicate:
a) Lever not in auto
b) Reset button not pressed to cancel alarm
|12Vdc or 24Vdc – 7Ah